DIY Perimeter Alarm To Protect Your Home&Camp

DIY Perimeter Alarm To Protect Your Home&Camp

DIY Perimeter Alarm To Protect Your Home & Camp

Are you looking for an extra layer of security to protect your home and camp? Protecting your property is important, but you don’t have to spend a fortune on expensive alarm systems. With some simple supplies, you can create your own DIY perimeter alarm to help keep your home and camp secure.

What You Will Need

  • Alarm – Most home improvement centers sell motion-detector alarms that may be used outside. Choose a model with a range of detection from 7-40 feet.
  • Batteries – Check the specs for the model of alarm you buy to determine the type and number of batteries required.
  • Screws – If you don’t have drywall anchors, you will need #4 or #5 flat head screws.
  • Cable ties, shielding tape, or zip ties – These are used to secure the wiring.
  • Cable – You may use a single insulated pair of copper wires for maximum flexibility.
  • Switch – These can be used to control the alarm and can be battery operated or mains operated.

How To Set Up The Perimeter Alarm

  1. Determine the alarm location. When installing the alarm, be sure to place it into an area that is difficult to avoid. Install the alarm as close to the ground as possible, so any intruder will not be able to walk around or over the device.
  2. Connect the alarm and switch. Use the cable ties, shielding tape or zip ties to secure the cable to the area you wish to protect.
  3. Test the alarm. Place the switch in the off position, and then activate the alarm. Listen for a faint beeping sound. If you hear the alarm, it has been properly connected and set up.
  4. Test the switch. Once the alarm is activated, turn the switch on. The alarm should deactivate. If the switch does not deactivate the alarm, replace the switch or batteries.
  5. Secure the alarm. Use the screws to secure the alarm to its mounting area. This will make it difficult for anyone to remove the alarm or tamper with it.
  6. Install the sign. Secure a security sign near the alarm to give intruders a visible warning.

Once you have completed these steps, your DIY perimeter alarm is ready to go! Whenever you leave your home or camp, be sure to activate the alarm. This will help to keep potential burglars away and ensure the safety of your property.

Leave a Reply

Your email address will not be published. Required fields are marked *